Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Early go!bus reflashing app for STM32-based modules

Started by Chris Walker, May 16 2012 03:36 AM

Please log in to reply

61 replies to this topic

#61 mtylerjr

Advanced Member

Members
106 posts

LocationChristchurch, New Zealand

Posted 24 August 2012 - 04:24 PM

Hi mtylerjr, Fabien:

Could you please plug your nwazet display module into socket 4 on your Netduino Go and then run the attached reflashing app?

Once flashing is done, the output window will show success and blink the power LED. When that happens, move the module to sockets 5-8 (so that the reflashing doesn't accidentally start over).

This should update your display module to the latest firmware from nwazet.

Chris