Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Seeeduino LCD

Started by Eric Burdo, Sep 06 2010 08:10 PM

Please log in to reply

3 replies to this topic

#1 Eric Burdo

Advanced Member

Members
130 posts

Posted 06 September 2010 - 08:10 PM

Took me awhile, but I finally found the right combination to make the Netduino control the Seeeduino 16x2 LCD panel..

Full details are here:

Brick Labs - Netduino and a 16x2 LCD

Posted Image

~ Eric D. Burdo ~ http://brick-labs.com/

Today LED's, tomorrow, the world!!! Well, OK, maybe servos.

Back to top

#2 dwfunk4475

New Member

Members
3 posts

Posted 02 May 2012 - 01:40 AM

Took me awhile, but I finally found the right combination to make the Netduino control the Seeeduino 16x2 LCD panel..

Full details are here:

Brick Labs - Netduino and a 16x2 LCD

The Brick Labs link is no longer valid. <frown>

-david

Back to top

#3 neslekkim

Advanced Member

Members
350 posts

LocationOslo, Norway

Posted 02 May 2012 - 04:52 AM

The Brick Labs link is no longer valid. <frown>

It seems like its only the front page that works now, none of the navigational links on the page like category, tags etc.
too bad.

--
Asbj�rn

Back to top

#4 KiwiDev

Advanced Member

Members
100 posts

LocationNew Zealand

Posted 24 June 2012 - 02:51 AM

Hi,

Seen as the links are broken, settings for Seeed LCD display plugged into BUS1

public static void Main()
   {
   var lcdProvider = new GpioLcdTransferProvider(Pins.GPIO_PIN_D2, // RS
                                        Pins.GPIO_PIN_D3, // ENABLE
                                        Pins.GPIO_PIN_D4,  
                                        Pins.GPIO_PIN_D5,  
                                        Pins.GPIO_PIN_D6,  
                                        Pins.GPIO_PIN_D7,
                                        Pins.GPIO_PIN_D8); 

   // create the LCD interface        
   var lcd = new Lcd(lcdProvider);         

   // set up the LCD's number of columns and rows:         
   lcd.Begin(16, 2);

   int i = 0;

   // print a message to the LCD.        
   lcd.Write("Hello Netduino!");         
   while (true)        
   {            
      lcd.SetCursorPosition(0, 1);

      lcd.Write(i.ToString()) ;
      i = i + 1;
      Thread.Sleep(100);        
   }    
}