I was having the same type of problems working with the ID-20 last night. Turned out the fancy see-through breadboard I got the other day wasn't making consistent contact on all wires.. This thread eventually lead me on to the cause, thanks! Only wish I had read it from the bottom up.. ;-)
Serial data problems
Started by Dan Morphis, Feb 10 2011 04:28 AM
21 replies to this topic
#21
Posted 19 February 2011 - 12:04 AM
#22
Posted 19 February 2011 - 05:55 PM
I was having the same type of problems working with the ID-20 last night. Turned out the fancy see-through breadboard I got the other day wasn't making consistent contact on all wires.. This thread eventually lead me on to the cause, thanks! Only wish I had read it from the bottom up.. ;-)
I'm glad this thread helped you! I spent way to much time trying to figure out the issue, until I woke up at 3 AM with an epiphany that if I can see the data on the scope, but not on the Netduino, then the pin is probably not making full contact.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users