Netduino 2 why not all pins were used ? - General Discussion - Netduino Forums
   
Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

Netduino 2 why not all pins were used ?


  • Please log in to reply
2 replies to this topic

#1 xmen

xmen

    Advanced Member

  • Members
  • PipPipPip
  • 72 posts

Posted 03 March 2016 - 09:53 AM

I've been looking at netduino 2 schematics and saw these pins were not used of STM32F205RFT6.

PA4
PA5
PA7
PA8 Reserved ?

PB0
PB1
PB4

PC8
PC9 Reserved ?
PC10
PC12
PC15 Reserved ?

PD2

Can I know the reason ? Is it because of making compatible to arduino ?

 

and why multiple pins for bootloader ?

PB11 and PC14, PC11, PB5

 



#2 Nevyn

Nevyn

    Advanced Member

  • Members
  • PipPipPip
  • 1072 posts
  • LocationNorth Yorkshire, UK

Posted 03 March 2016 - 07:55 PM

The Netduino is designed to be pin compatible with the Arduino.  The layout is the same but the voltage is different.

 

Regards,

Mark


To be or not to be = 0xFF

 

Blogging about Netduino, .NET, STM8S and STM32 and generally waffling on about life

Follow @nevynuk on Twitter


#3 xmen

xmen

    Advanced Member

  • Members
  • PipPipPip
  • 72 posts

Posted 04 March 2016 - 02:12 AM

So can I use those pins if I use netduino firmware ?






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.