Best Answer JerseyTechGuy, 08 February 2013 - 07:35 PM
Sorry about the delay. I was going to design it all in Fritzing and post the Fritzing file, but not all the parts are available and I haven't figured out how to create the fritzing parts yet. So here is just a photo. The blue board is the one from Adafruit and is the charger, the smaller Sparkfun is the fuel gauge and the square Sparkfun is the StepUp 5V. You can grab the actual pin outs from the Sparkfun and Adafruit site but the connection is shown below. If you decide to use the fuel gauge let me know and I can post up a class polling the fuel gauge.
Go to the full post