Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Netduino unresponsive

Started by Ramiro, Aug 25 2012 07:02 PM

Please log in to reply

3 replies to this topic

#1 Ramiro

New Member

Members
1 posts

Posted 25 August 2012 - 07:02 PM

my netduino stopped responding,
apparently it's alright because LEDs are functioning normally until it is recognized, but when I try to publish the Visual Studio it is charging for the same occurs when accessing the settings by MFDeploy.exe.

Back to top

#2 Victor M.

Advanced Member

Members
39 posts

LocationRio de Janeiro, Brazil

Posted 27 August 2012 - 02:08 AM

Hello Ramiro,
You could reset Netduino Plus Board applying this procedure in Netduino Wiki.

Back to top

#3 Chris Walker

Secret Labs Staff

Moderators
7767 posts

LocationNew York, NY

Posted 28 August 2012 - 07:53 PM

Hi Ramiro, Can you give us a bit more detail on your situation? Does the board boot properly and run the app which is currently flashed on it? When you try to ping it from MFDeploy, what response do you get? Chris

Back to top

#4 nakchak

Advanced Member

Members
404 posts

LocationBristol, UK

Posted 29 August 2012 - 09:03 AM

Hi Ramiro

If you upgraded to 4.2 did you try and set the network settings?
If so it sounds like the issue people are reporting to do with trying to set the network config whilst in tinyclr mode.

If thats the case you will need to reflash the board using the instructions exactly as they are written in this thread

Nak.