Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Boiler controller

Started by alesbedac , Aug 27 2015 06:48 AM

Please log in to reply

No replies to this topic

#1 alesbedac

Advanced Member

Members
63 posts

Posted 27 August 2015 - 06:48 AM

Hi All,

my current project is Boiler temperature controler.
PCB Shield description
* 7xDS18B20 (if i will use sensor indexing than i can connect much more sensors)
* 7x digial Outpout (12-24V DC)
* 6xdigital inputs (12-24VDC) or SPI LCD. If I2C lcd is used, than are these inpust available.

* and pinheader for i2c device (with 5 pins, 2 are data, one is GND aaand 5V and 3V3

Curently i am using 4 sensors. and COM1 is conntected with bluetooth UART adapter to conenct with PC, what is now for upload parameters. These parameters are saved to I2C eeprom. I am using RTC DS1307 Shield with build in eeprom. On i2C bus i have next devices - 2x LM75 (temp sensor). One is for Indoor temperature and the second is for outdoor temperature. Picture show you 4 relais to switch valves.

Thats all for now :-).