Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

Reset N2+ to firmware


  • Please log in to reply
2 replies to this topic

#1 kalio20

kalio20

    Member

  • Members
  • PipPip
  • 22 posts

Posted 08 February 2015 - 02:14 PM

Hi,

 

i tried to use some example programms found anywhere, some worked some not. So I tried to installed the new Firmware:  v4.3.1, after finishing i tried to run my old examples, but non of them worked after installing the firmware. So i tried to reset my Board, do devilery Firmware, but all failed and i dont know what to do now. How can I reset it to the standards?



#2 Chris Walker

Chris Walker

    Secret Labs Staff

  • Moderators
  • 7767 posts
  • LocationNew York, NY

Posted 09 February 2015 - 04:29 AM

Hi kalio20,

You can get the factory default 4.2 firmware here:
http://forums.netdui...-v422-update-2/

Chris

#3 timothyp

timothyp

    Member

  • Members
  • PipPip
  • 24 posts

Posted 10 February 2015 - 02:59 PM

 

 

after finishing i tried to run my old examples, but non of them worked after installing the firmware

 

Just to make sure, after upgrading to 4.3.1, did you change the project properties so it targets .NET MF 4.3 instead of 4.2?

And any time you get really stuck, the update tool will safe the day: http://forums.netdui...&attach_id=3167






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.