Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Building Gobus.dll

Started by beastyboy , Aug 16 2014 02:55 PM

Please log in to reply

2 replies to this topic

#1 beastyboy

Advanced Member

Members
194 posts

LocationNetherlands

Posted 16 August 2014 - 02:55 PM

Hi,

I am trying to build de Gobus.dll from the 4.2 sdk.

When I try to deploy the newly build dll it does not replace the already installed dll file.

It deploys the pe file.

Any ideas how to do this ?

Cheers

Olaf

^V_an_Sch^O_ten^I_ct ^D_iensten_en^S_ervices
http://www.voids.nl

#2 beastyboy

Advanced Member

Members
194 posts

LocationNetherlands

Posted 16 August 2014 - 03:35 PM

Hi,

Problem was not that difficult recycling the power showed the correct dll file.

Cheers Olaf

^V_an_Sch^O_ten^I_ct ^D_iensten_en^S_ervices
http://www.voids.nl

#3 beastyboy

Advanced Member

Members
194 posts

LocationNetherlands

Posted 16 August 2014 - 05:17 PM

Is there a way to remove the old GoBus.dll from the netduino ?

I get the feeling that even if I have referenced my new dll the old one is already loaded and uses the outputs port defined in them.

^V_an_Sch^O_ten^I_ct ^D_iensten_en^S_ervices
http://www.voids.nl

Back to Netduino Go

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

Community Forum Software by IP.Board 3.4.8

home hardware projects downloads community where to buy contact

This webpage is licensed under a Creative Commons Attribution-ShareAlike License.

Building Gobus.dll

#1 beastyboy

#2 beastyboy

#3 beastyboy

0 user(s) are reading this topic

Sign In