Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

Deployment problem


  • Please log in to reply
2 replies to this topic

#1 Paul Ebert

Paul Ebert

    New Member

  • Members
  • Pip
  • 6 posts

Posted 17 March 2012 - 10:54 PM

I just successfully completed the "Getting Started" exercise on my brand new N+ and was able to run it a few times. I also set a breakpoint and did a tiny bit of stepping through the code. Now, when I try to deploy again, it churns on "Preparing to deploy assemblies to the device" for quite a while and comes back with the error that it is unable to communicate with the device via USB. The power LED is illuminated and the blue LED is flashing at the 1/4 second rate. Suggestions?

#2 Paul Ebert

Paul Ebert

    New Member

  • Members
  • Pip
  • 6 posts

Posted 19 March 2012 - 04:25 PM

As mysteriously as it stopped working, it started again. So, please ignore.

#3 DrJaymz

DrJaymz

    Advanced Member

  • Members
  • PipPipPip
  • 42 posts

Posted 19 March 2012 - 09:32 PM

As mysteriously as it stopped working, it started again. So, please ignore.


Yeah, it does that. A lot.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.