Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

Computer doesn't recognize plus 1


  • Please log in to reply
2 replies to this topic

#1 vz10

vz10

    New Member

  • Members
  • Pip
  • 8 posts

Posted 19 December 2014 - 07:41 AM

I've tried to deploy 4.2 firmware on netduino plus, but after erasing it by tapping erase pad computer doesn't recognize it. It can't find it in MFDeploy, I don't know what to do. Can I burn it while erasing?

#2 w3n

w3n

    New Member

  • Members
  • Pip
  • 4 posts

Posted 30 December 2014 - 03:00 PM

that's a normal behaviour, you 'll need SAM-BA and install a driver to emulate a COM port to be able to connect to the device, follow the steps at this guide, it worked for me -and I'm a total noob on this - so must work for you.

 

http://wiki.netduino...ep-by-step.ashx

 

Good luck!



#3 vz10

vz10

    New Member

  • Members
  • Pip
  • 8 posts

Posted 09 January 2015 - 12:42 PM

Thanks for your advice, I've done everything from than post, but the last step (reconnect and start MFDeploy) doesn't work. I still don't see netduino in MFDeploy, but I see it SAM-BA. 






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.