Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

USBControler configuration don't update

USBClient UsbClient.Configuration idVendor

Best Answer Chris Walker, 31 October 2013 - 02:28 PM

Hi borice, The USB configuration is fixed on Netduinos. You can hack it a bit with the gen1 Netduinos, but it's not an officially-supported feature on either board. We did design some extra hardware into the gen2 Netduino boards though that may make this possible in the future. Chris Go to the full post


  • Please log in to reply
2 replies to this topic

#1 borice

borice

    New Member

  • Members
  • Pip
  • 1 posts

Posted 31 October 2013 - 08:15 AM

I've tried some sample for USB communication using netduino 2 and .Net Microframework 4.2 but none of them are working correctly.

 

The configuration of the UsbControler doesn't change after being grammatically changed in the netduino. So the computer still detecting a netduino 2 device instead of the configured device. I'd also tried to load the UsbControler configuration but it's the same problem.

 

How to proceed to change the UsbControler configuration with a netduino 2 ?

 

Thanks for your reply,

 



#2 Chris Walker

Chris Walker

    Secret Labs Staff

  • Moderators
  • 7767 posts
  • LocationNew York, NY

Posted 31 October 2013 - 02:28 PM   Best Answer

Hi borice, The USB configuration is fixed on Netduinos. You can hack it a bit with the gen1 Netduinos, but it's not an officially-supported feature on either board. We did design some extra hardware into the gen2 Netduino boards though that may make this possible in the future. Chris

#3 donnmo

donnmo

    Member

  • Members
  • PipPip
  • 28 posts
  • LocationSpokane area

Posted 15 November 2013 - 11:41 PM

Chris,

 

Is driverless USB communication (via HID) supported on the Netduino 2 or Netduino 2 Plus? (Or, is it only working on the v1 boards? And, if the latter, are there plans to support it on the v2 boards?)

 

Thank you,

--Donn Morse







Also tagged with one or more of these keywords: USBClient, UsbClient.Configuration, idVendor

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.