Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Netduino 1 Plus - can't set network config after upgrade to 4.2.1

Started by Audiobuzz, May 11 2015 05:20 AM

Best Answer Audiobuzz, 11 May 2015 - 11:46 AM

Weird...I tried it three times tonight and each time I got the same "unable to erase configuration memory" error.

Then I tried it a fourth time and it worked. Must be a timing thing.

Thanks Chris, Appreciate your help

Go to the full post

Please log in to reply

3 replies to this topic

#1 Audiobuzz

New Member

Members
3 posts

Posted 11 May 2015 - 05:20 AM

Hi All,

I've recently upgraded my Netduino 1 Plus to 4.2.1 using a Windows 10 VM running on Mac (VMware fusion).

Everything went well except when I go to re-set the MAC address using the standard MFDeploy, I get the all too common failure. I tried the 'custom' version of MFDeploy they Chris posted but it won't detect my netduino using USB so won't let me set anything.

What am I doing wrong?

Thanks

Jarrad

Back to top

#2 Chris Walker

Secret Labs Staff

Moderators
7767 posts

LocationNew York, NY

Posted 11 May 2015 - 05:32 AM

Hi Jarrad,

Can you try this really quickly?

Press and hold the pushbutton while powering up your board.
Press Ping in MFDeploy. You should see "...TinyBooter."
Update your network configuration in MFDeploy.
After saving the config, unplug and reattach your Netduino Plus 1.

Does that work for you? VMs can be dodgy and Windows 10 is still beta...but there should be a way to get this to work...

Chris

P.S. The 4.2 firmware for Netduino Plus 1 uses WinUSB, so you'll need to use the MFDeploy that comes with one of the newer NETMF SDKs.