[font="'courier new', courier, monospace;"]Hi[/font]
[font="'courier new', courier, monospace;"]I am busy doing a project (battery management system for a 4x4) where i want to mount the netduino module on a breadboad. The reason for this is mainly vibration and i want pin connections instead of wires as far as possible.[/font]
[font="'courier new', courier, monospace;"]My problem is that i do not want to mount the Netduino module face down. (Want to be able to access the reset button, sd card etc ...) All the input and output pins facing upwards.[/font]
[font="'courier new', courier, monospace;"]Possible solutions:[/font]
[font="'courier new', courier, monospace;"]1) Unsolder the connector blocks and turn them around. (What is the risk of damaging the module?)[/font]
[font="'courier new', courier, monospace;"]2) Build a connector block next to the current blocks and link the pins with a piece of veraboard. (see attached image)[/font]
[font="'courier new', courier, monospace;"][font="georgia, serif;"]Any other suggestions?[/font][/font]
[font="'courier new', courier, monospace;"][font="georgia, serif;"]Thanks[/font][/font]
[font="'courier new', courier, monospace;"][font="georgia, serif;"]Wil[/font][/font]