jwjames83's Content

#48693 Netduino Plus 1 Firmware v4.2.0 (update 1)

Posted by jwjames83 on 24 April 2013 - 05:01 PM in Netduino Plus 2 (and Netduino Plus 1)

So is this for the plus or the normal? I bricked my Netduino following these directions. I just noticed the topic says Netduino but the file says "NetduinoPlus". So now i don't know what the heck to think. I am getting the "COM GPS Detect" driver thing, really wishing I just left good enough alone, the thing is 3 days old and a I fear a brick now

The title "Netduino Plus Firmware v4.2.0 (update 1)" should be read as "Netduino Plus Firmware" not "Netduino and Firmware".

#45195 Status of MonoDevelop

Posted by jwjames83 on 09 February 2013 - 06:45 AM in Mono

I too would like to know the status.

Thanks!

#41442 Netduino Plus 1 Firmware v4.2.0 (update 1)

Posted by jwjames83 on 12 December 2012 - 08:43 PM in Netduino Plus 2 (and Netduino Plus 1)

Same problem here. I keep getting "unable to erase configuration sector memory" as well when trying to change the network settings.

Bah! Silly me -- it's plastered everywhere. Sorry for not looking harder! Now, to figure out some other issues!
http://wiki.netduino...duino-Plus.ashx

Note: If your running the 4.2 or later firmware, you need to hold down the onboard button while you plug in the USB to put your device into bootloader mode.

#41407 Netduino Plus 1 Firmware v4.2.0 (update 1)

Posted by jwjames83 on 11 December 2012 - 08:28 PM in Netduino Plus 2 (and Netduino Plus 1)

Same problem here. I keep getting "unable to erase configuration sector memory" as well when trying to change the network settings.

#34084 TI CC1101 & Netduino

Posted by jwjames83 on 23 August 2012 - 04:50 AM in General Discussion

Just curious if anyone has messed with a Texas Instruments CC1101 and how successful they were with it. I seem to be running into a brick wall and cannot get SPI working with it.

In case anyone is interested, here's the data sheet.
http://www.ti.com/li...link/cc1101.pdf

I can post the code if anyone would like and maybe help point out where I'm going wrong.

#31165 OLED / LCD Buttons or Switches

Posted by jwjames83 on 24 June 2012 - 06:06 PM in General Discussion

Has anyone interfaced with any type of programmable OLED or LCD switch button? It looks like the two major players are NKK and ScreenKeys. NKK Programmable Switches - http://www.nkkswitch...mmableSwitches/ ScreenKeys LCD Switches - http://www.screenkey...gb_series.shtml I'd like to integrate up to 8 of these in a project and would like some feedback if anyone has used these, or anything similar. Thanks!