The specs of the netduino plus 2 says that you need a poweradapter with a voltage of 7,5 - 9 V, but what about the current ?

If I have an adapter 7,5V - 300mA is that a possible configuration, or should I use an 7,5V - 1A adapter, or maybe the Netduino Plus 2 needs a higher current.

Can someone tell me what adapter I need to use ?

Hi Escallanio,

I did not use DfuSe to update the firmware, I used NetDuinoUpdate for it.

I don't know what the differences are between DfuSe and NetDuinoUpdate.

Maybe there is a small bug in the 4.3.1 firmware which causes this problem.

Thanks,

WillyBilly

Hi Chris,

Thanks for your reply

I tried to deploy from VS2012 and yes that works.

I used the Netduno Update to flash the firmware to version 4.3.1.0

Now, after I deployed with VS2012, MFdeploy can erase and deploy the board fine.

The first time MFdeploy says error erasing, but no "no response from device", the second time it erases fine and I can deploy a new .hex file.

So the problem is solved for now, but is it a bug in the Netduino board or in MFdeploy ?

I have a strange problem with my Netduino Plus 2 board.

I deployed a hex file by MFdeploy in it, but I received a new version of the hex file and now I want to erase and deploy the new hex file to the Netduino Plus 2.

The problem is that everything looks fine, I can ping the board by MFdeploy, I can reflash the firmware, I can change the IP settings, but when I want to erase or deploy the Netduino, then it says: Error: no response from device.

I tried it on another computer and there appears the same problem.

What is going wrong?