William Basser's Content

#35878 Netduino Plus Update

Posted by William Basser on 24 September 2012 - 04:03 AM in Netduino Plus 2 (and Netduino Plus 1)

Found it and got it working. Thanks for the help.

#35817 Netduino Plus Update

Posted by William Basser on 22 September 2012 - 02:07 PM in Netduino Plus 2 (and Netduino Plus 1)

I have cleaned up my hard drive, re-installed all the items from the download page and there is no tinybootercompressor.hex or ER_FLASH ER_CONFIG files anywhere.

#35737 Netduino Plus Update

Posted by William Basser on 21 September 2012 - 10:42 PM in Netduino Plus 2 (and Netduino Plus 1)

I have done that. I need to restore the tiny booter as well as the board is clean. Where do I get the images for the tiny booter and the firmware?

#35733 Netduino Plus Update

Posted by William Basser on 21 September 2012 - 10:14 PM in Netduino Plus 2 (and Netduino Plus 1)

One thing I noted is you keep referring to Version 4.2.0.1, where do I get this firmware?

#35419 Netduino Plus Update

Posted by William Basser on 17 September 2012 - 01:53 PM in Netduino Plus 2 (and Netduino Plus 1)

I downloadded the new firmware and went throught the cycle again. When I go to deplay the firmware, I go through the sequence, with the follwing info from the deploy window: Chk signature S At this point the led on the device goes out. If I re-connect and attempt to quiry the device capabilities, I get Error: No response from device. I have verified that I have the latest firmware. The boot loader seems to function properly as well as being able to communicate to the device with the boot loader, i.e. I can set the network address and such. I would appreciate any help you can give on this.

#35379 Netduino Plus Update

Posted by William Basser on 16 September 2012 - 06:09 PM in Netduino Plus 2 (and Netduino Plus 1)

I have a netduino plus rev b board. I updated the boot loader with Sambo with no errors. I then attempted to download the new firmware through MFDeploy. The unit pins successfully, I then select both ER_CONFIG and ER_FLASH files. I get the message that it is erasing and deploying, but it does not complete. I have attached a screen shot below. Pinging... Error: No response from device Pinging... Error: No response from device Pinging... TinyBooter Bootloader build info: Netduino Plus (v4.2.0.0 RC3) by Secret Labs LLC Chk signature SignatChk signature SError: No response from device Not Supported Pinging... TinyBooter Bootloader build info: Netduino Plus (v4.2.0.0 RC3) by Secret Labs LLC Not Supported Error: No response from device Any ideas?