Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Zhest

Member Since 20 Aug 2011
Offline Last Active Jun 30 2015 12:08 AM
-----

Posts I've Made

In Topic: Dead USB, can't deploy, connect or reset...

30 June 2015 - 12:09 AM

If you plug the board into your PC while firmly holding down the pushbutton--and the blue LED does not turn off--then it is either in bootloader mode or the board is damaged. If it is bootloader mode, you'll get device enumeration via USB. If it doesn't enumerate (on any PC) in this condition, then something somewhere has is damaged :( Chris

 

I finally just found this. Sadly then, it seems my new boards are broken. Not seeing anything under the Other Devices or Ports sections of the device manager while clearly in bootloader mode.

 

This was driving me nuts, I was so sure I was following everything to the letter. Glad I can finally put it to rest. 


home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.