Netduino home hardware projects downloads community

Jump to content

  2. → Viewing Profile: Posts: Adamos

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Adamos

Member Since 18 Aug 2011
Offline Last Active Jan 06 2012 08:13 PM
-----

Posts I've Made

In Topic: Xbee Wrong Text - Help

03 November 2011 - 03:42 PM

Hi,

The baud rate is important, but the speed doesn't matter. As long as both the XBee and Netduino have the same setting. So if you set them both at 9600 it should work fine!


Both Xbee and Netduino have the same setting!

In Topic: Xbee Wrong Text - Help

30 October 2011 - 02:12 PM

Check your baud


Thanks, which rate you suggest?? i currently use 9600

In Topic: XBee/Zigbee wireless, where to start?

26 August 2011 - 04:46 PM

aloxa guys i have also buy this modules but i set the baud rate to 9600. is that wrong???

In Topic: ESC - Code Problem

26 August 2011 - 03:05 PM 


           **** SpeedController xl5 = new SpeedController(Pins.GPIO_PIN_D5, new TRAXXAS_XL5());

Well my ESC in not a TRAXXAS one. I have seen similar code and i thing so that need a another one class in order to instansiate
SpeedController() .

In Topic: ESC - Code Problem

26 August 2011 - 02:54 PM

Oh dear! That did hurt I suppose? :o


Thanks guys for ur help i will try it out i will let you now about my progress!!!!

Well i am always be carefull with this things coz am using a jet motor!!!! :P (i saw similar motor working)

  1. Netduino Forums
  2. → Viewing Profile: Posts: Adamos
  3. Privacy Policy
home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.