Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Nissim

Member Since 23 Jul 2011
Offline Last Active Jun 14 2013 06:18 AM

Find content

Posts I've Made

In Topic: SAM BA 2.12 " No valid process id found"

11 June 2013 - 08:41 AM

Thanks for your reply. I am using Sam7x512 ek. My board has max232 . I am using a pc with serial db9 socket. Some reason. Out of 10 tried it might connect to Sam ba 2.12 once. I am keen to figure out why.

In Topic: Signature check fail Er_flash.sig

11 April 2013 - 06:24 AM

Thank you for your reply

After uploading ER_flash and ER_Config

When I ping I get " Pinging... TinyBooter"

I can not deploy my firmware

It get stuck on "Preparing to deploy assemblies to the device "

I would appreciate any further advice

Nissim

In Topic: Signature check fail Er_flash.sig

10 April 2013 - 10:51 AM

thank you

i tried and i get same results

In Topic: Magjack RJ45 interface to DM9161 network IC

30 March 2013 - 09:30 PM

Thank you for your reply Chris

Following your advice, I noticed that the orientation of transformer on Magjack does not match exactly as on HX1198NL IC . Could this cause the problem I have?

The DM9161 initialising because I get correct register status.

The LEDs on my board seem to behave same as on kit I have

Thank again for your good on going support

In Topic: USB for custom made board

19 November 2012 - 08:22 AM

My PCB has same wiring as netduino plus kit except 2 wires bus, analog and mux . I am scratching my head why Netduino plus firmware tools work on my kit but not on my custom made PCB

Nissim

Community Stats

User Tools

Friends

Posts I've Made

In Topic: SAM BA 2.12 " No valid process id found"

In Topic: Signature check fail Er_flash.sig

In Topic: Signature check fail Er_flash.sig

In Topic: Magjack RJ45 interface to DM9161 network IC

In Topic: USB for custom made board

Nissim

Community Stats

User Tools

Friends

Posts I've Made

In Topic: SAM BA 2.12 " No valid process id found"

In Topic: Signature check fail Er_flash.sig

In Topic: Signature check fail Er_flash.sig

In Topic: Magjack RJ45 interface to DM9161 network IC

In Topic: USB for custom made board

Sign In