Stanislav Husár - Viewing Profile: Topics - Netduino Forums
   
Netduino home hardware projects downloads community

Jump to content

  2. → Viewing Profile: Topics: Stanislav Husár

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Stanislav Husár

Member Since 05 Jul 2011
Offline Last Active May 10 2018 09:48 AM
-----

Topics I've Started

Custom board derived from Netduino

11 July 2015 - 07:54 AM

Hi everyone,

 

I would like to ask you for help.

I am designing custom board derived from Netduino. The basic aim is to have a lots of GPIO on just one board. I have done my first scheme. But I have never done this before. So I really do not know, if my scheme is correct.

Could you please check my scheme for any design errors, bad practice, etc. , and also set correct packages for all components?

 

Attached is my version of the scheme, made in Eagle 7.3.0 light, renamed to .txt so I can upload it here.

 

My last question, when I solder fresh new MCU on the board, does it already contain minimum code needed to communicate with STDfuse demonstration tool over USB? Or I have to flash something over MCU's programming interfaces?

 

Thanks in advance.


Unable to compile Netduino firmware

26 May 2015 - 01:53 PM

Hi,

 

I want to add support for Microsoft.SPOT.Graphics to my Netduino 2. I know that this requires firmware modification. I have tried http://wiki.netduino...to-GCC-4-6.ashx, but I have got many errors, I don't know why. Attached is MSBuild log.

 

Thanks in advance.


Driving Adafruit ST7565 display

23 May 2015 - 09:56 AM

Hi,

 

I am trying to get my ST7565 display working with Netduino. I thought it will be simple. I compiled sources of Netduino helpers library on codeplex.com and referenced to my Netduino 2 project. Surprise came when I tried to run this code. It compiled, deployed, and that is all. When I removed Netduino helpers library from references, and run project, I saw my Debug.Print outputs in Visual Studio. This proves that problem is Netduino helpers library itself. Unfortunately, I don´t know about any other library, capable of driving my display.

 

Do you know about some other way to communicate with the display, than Netduino helpers library? 


  1. Netduino Forums
  2. → Viewing Profile: Topics: Stanislav Husár
  3. Privacy Policy
home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.