Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

maliman

Member Since 15 Oct 2012
Offline Last Active Jul 04 2013 04:46 AM

Find content

Received

#49350 Strange I2C behavior on Netduino Plus 2

Posted by maliman on 11 May 2013 - 06:04 AM

Hi All, I'm having no problem using I2C on Netduino Plus board. But as soon as I use NP2 I2C, bus transaction doesn't shows in oscilloscope. After doing some digging I found out that I2C transaction will start only if I connect the I2C slave after the NP2 finish initilization process. Meaning I have to wait after NP2 finish initialize and then connect the I2C slave. It doesn't happen with NP board, where i don't have to disconnect I2C slave everytime the NP reboot process. I've upgrade my NP2 firmware to v4.2.2.2. Thanks.

Nizam

kineyed likes this

maliman

Community Stats

User Tools

Friends

#49350 Strange I2C behavior on Netduino Plus 2

maliman

Community Stats

User Tools

Friends

#49350 Strange I2C behavior on Netduino Plus 2

Sign In