me62

The Best Answer failed for me also. I get a runtime error when install it on my Windows 7 computer.

I posted a bug report http://netmf.codeple...m/workitem/1943

I am using a Netduino Plus 2, with upgraded firmware to v4.2.2 Update 1. I followed all the hints provided in the previous post.  But I found that I had to remove all references to 'static' in my assembly  This is hard to accept that I can not write a program using static.  Is this something to do with .NETMF v4.2?

I found that I could not use any static variables, methods, etc in my assembly run from the SD card. Then even with this "message" the program runs fine...  I did not have this issue with v4.1.  I am using v4.2.  Is there a newer version I maybe should be using?

I actually tried with an assembly following the example provided in http://fabienroyer.w...ith-a-netduino/ and I get the error but no issues proceeding. The ASSM.pe file from the example is only 1K.  Maybe this is specific to my assembly, but I would still like to know what is causing the message 

Invalid address 0 and range 40 Ram Start 20000000, Ram end 20020000