Vallekano

Hello, I hope you can help me. I'm using Google translator, I do not speak good English. I'm doing a quadcopter and there is something I do not understand. I used a library to control servos and have it modified to run the motor with ESC. The problem is as follows: - If I connect the Netduino and then connect the ESC to the battery everything works fine. - But if I connect two devices at once from the beginning, the ESC does not start well. Does not beep it is connected. Must always be the Netduino already connected before power is applied to the ESC. This is correct and should control it with a relay or something that escapes me.

Hello, The first thing to say is that I do not speak English and I apologize for my bad English. I would like to use an RC transmitter to interact with the Netduino like this: http://blog.bricogee...pm-con-arduino/ http://sites.google....do-del-receptor I've seen this post: http://www.arduino.c...?num=1199165055 But I think I can not read the PPM signal with Netduino API. I've seen here talking to simulate the "PulseIn" http://forums.netdui...sensor/&.google Could connect an RC transmitter in our Netduino? Thanks