mrb0y

I got mine installed and updated. The problem was an incorrect selection for the chip on the Atmel tool. After I installed the 2.10v SAM-BA the pull down list had more selections including the one I was looking for. The tool does not default to the tab required to do the update though still allows you to choose a firmware and upload.

I'm having a problem trying to update from 4.1.x. I unfortunately followed the instructions step by step assuming that if there were issues it would be documented. I zeroed my Netduino by 3.3v to the square and set about installing the ATMEL software on my windows 7 64bit machine only to find out that I'm not able to connect to the netduino??? Now I'm stuck with a bricked netduino and no way to update? I tried re-installing and several attempts at connect via the sam-cb. It sees the connection to USB and asks for a chip type and com port but after that it just sits there??? Any help would be greatly appreciated. I suggest that on the instructions to update the boot loader your preface the procedure with the "if is doesn't work for you you might want to try..." before the zeroing of the device.