Hi Phil,I have a Netduino Plus on order from Sparkfun. Hoping it comes soon. I have been playing with the color LCD shield on an Uno and got it working pretty well after removing the 33 ohm resistor in series with the switcher input that was dropping the 5v to about 2.5 and making some heat. That could never have possibly worked! Anyway I have been using the bit banged SPI software library that Mark Sproul wrote and the very helpful tutorial in tronixstuff. I want to use this shield with a Wifly shield both using the SPI peripheral of the AT19 with different CS for each. If you post a library I will try it as soon as the board shows up.
i have the same color lcd >this lcd work correctly on atmega board, but with Netduino, not work..blue screen at init.
I dont removed the 33 ohm..where is this resistor?
I used spi bit banging with:
D8 = lcd_dc
D7 = lcd_rst
D4 = lcd_cs (as in sw)
D13 = lcd_clk (as in sw)
D11 = lcd_mosi (as in sw)
Thanks,
Andrea