Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Eric Burdo

Member Since 04 Sep 2010
Offline Last Active Jun 11 2013 10:13 PM
-----

Topics I've Started

How to reflash the "Beta" versions of the Netduino Plus

22 May 2011 - 08:16 PM

I want to put the latest Beta firmware on my nd+. However, I have one of the early September models, and one of the forum posts said to erase the original, and put the new bootloader on it. However, I can't seem to find the ERASE pad that everyone talks about. I found it easily on my original Netduino, but there is no gold ERASE pad below D0 on the nd+. Anyone have a screenshot showing where this would be?

Where to start - radio controller to Netduino communication

02 December 2010 - 02:32 AM

I have a couple of these (bought them for like.. $10 each, brand new).

Posted Image

http://www.vexroboti...m/276-2153.html

I'd like to interface that with my Netduino...

Any suggestions on where to begin?

MakerShield for the Netduino

28 November 2010 - 07:16 PM

Just found this in my email...

Posted Image

(click the image to go to MakerShed)

Introducing the MakerShield kit - The ultimate open source prototyping shield for Arduino & Netduino micro-controllers


I might pick on up after Christmas. They take a mini-breadboard, so you can then do solderless breadboard work, right on the shield.

Simple Logic Probe

27 November 2010 - 01:18 PM

This recently came up in my RSS feeds... and I thought I'd pass it along here.

It's nothing to do with the Netduino directly... but it's quite handy for your electronics tools collection. :)

http://profmason.com/?p=1426

There is a link in the article of Prof Mason's, going to another view and explanation of the Logic Probe.

Posted Image

Controlling a 7 Segment display, w/out shift registers

05 October 2010 - 02:19 PM

I didn't have any shift registers available, so I wrote this to control the 7 segment display without using a shift register. http://brick-labs.co...shift-register/ Video, picture and source code available.

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.