Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Coding Smackdown

Member Since 25 Aug 2010
Offline Last Active Feb 26 2024 09:24 PM
-----

#35525 How to install (or upgrade to) .NET Micro Framework v4.2 SDK

Posted by Coding Smackdown on 19 September 2012 - 05:42 AM

Thanks that worked out just fine.


#35079 Homebrew fermentation temperature controller

Posted by Coding Smackdown on 12 September 2012 - 09:47 PM

I bought several of the relays for SparkFun to do just what your talking about and they work fine for things like the fridge, freezer and pump motors. I wouldn't try to drive a Water Heating element with them though. I was searching for a good thermocouple/thermistor for one of my mod projects and found that Brewer's Hardware have several different types you could purchase that work OK. I just stay away from the temp probes for the Brewtroller since they use One-Wire support and right now the Netduino does not support One-Wire communications without dropping back to version 4.1. I found out that they have both Positive and Negative temperature coefficient temp probes so you might want to call them to make sure you get one that is a negative coefficient probe and then you can use any of thermistor code out on the arduino forums to read the probes. I've also posted a lot about my Netduino Brewing Projects out on my site http://diybrewery.com and am in the process of putting together a book on my projects. Good Luck! I'm looking forward to what you come up with.


#30214 Brewing Beer with a Netduino Plus

Posted by Coding Smackdown on 05 June 2012 - 05:13 AM

I've been working on a new brewing project and have gotten far enough along to start showing it off to folks. I've been working on modifying an Electric Turkey Fryer that I can use to brew small batch of beer for competitions and such. I based the temperature control off of my previous DIY Brewery Temperature Monitor project and enhanced it to allow the user to enter in a temperature that the Netduino will work to maintain during the mashing process. I've also added buttons to control the system for those times when I don't have a network handy along with a LCD Display to show the current status of the system. I'm still waiting for the circuit boards to come back from BatchPCB.com so I can assemble the system in a nice control panel. You can read about it over at my DIY Brewery Blog at http://diybrewery.com


home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.