bradygaster

After trying this willy-nilly a few times, it worked. Was able to flash my bad code from my N3, now I'm cooking up a new robot. 

I've tried:

Uninstall SDK

Reboot

Reinstall SDK

Reboot

Run the updater

I keep seeing the same error each time - the dialog opens and I click Options, then select Netduino 3 WiFi. I change this and the dialog says "Note: These settings, stored in non-erasable storage, may be changed up to 0 more times."

The main Netduino Update window always says "STM Device in DFU Mode." 

All I want to do is erase the horribly awry code that's running on it. Help!

I couldn't find a fritznig model for the Seeed motor driver, so that's implied as atop this one. In this you'll see the Netduino and how it drives the ping. The Netduino does get power from the motor driver, but it doesn't drive the ping sensor at all. Seems like re-routing some additional channels (VIN, maybe?) to the breadboard and back again might make things work better for the Netduino?

I also attached the best photo I could find of the shield for your review. The Netduino runs from 5V/GND/Digital to the Ping. Works just fine so long as the Netduino is plugged into USB. 

Thanks for your review and assistance!

The "Erase App" button is amazingly helpful. Thank you. Best. Thing. Ever. 

I was able to fix this. Not sure if this was buried in the forums but if not, here's the link to the newest one. Once I installed this everything worked. 

http://www.st.com/st...sw-stm32080.zip