louyo

Lazy man's question: Did something change with the com ports between Netduino Plus and Netduino Plus 2? I moved a working application from the Plus to the Plus2 and it fails in the com port routine. Tried both 1 and 2. If there is no known problem, I will carry on debugging.

 

Louyo

Trying to test a camera with the AdaFruit VC0706 test sample. I can run a small program that tests the SD card and some simple stuff, although sometimes I have to hit the reset button on the N+.
When I run that sample program, I get:
-----------------------------------------------------------------------------------------
------ Build started: Project: AdaFruitVC0706Test, Configuration: Debug Any CPU ------
AdaFruitVC0706Test -> E:\netduino\netduinohelpers_249dd927c92e\Samples\AdaFruitVC0706Test\AdaFruitVC0706Test\bin\Debug\AdaFruitVC0706Test.exe
------ Skipped Deploy: Project: netduino.helpers, Configuration: Debug Any CPU ------
Project not selected to build for this solution configuration
------ Deploy started: Project: AdaFruitVC0706Test, Configuration: Debug Any CPU ------
An error has occurred. Please check your hardware========== Build: 1 succeeded, 0 failed, 1 up-to-date, 0 skipped ==========
========== Deploy: 0 succeeded, 1 failed, 1 skipped ==========
---------------------------------------------------------------------------------------------------

Does this point to hardware problem or short circuit between the headphones?

Lou

I am newbie. Firmware is 4.1.0.6, SDK is 4.1 I can load and run the blinky program if I select run without debugging. If I select F5 (debug), I get 2 lines saying "Deploy started: Project Blinky, Configuration: Debug Any CPU" After some time, I get "rebooting.... Done" in the output window but the program does not run properly. If I set a breakpoint in the Main loop, and then hover over that BP, it says "The breakpoint will not currently be hit. The specified module has not been loaded. If I run without debugging, the program will load and run but any rebuild requires the reset button to be pressed before it will load and run again. I am sure that this worked OK at one time but it has been several weeks since I used it. Thanks for any help and apologies if I missed this in a search. Lou