Netduino home hardware projects downloads community

Jump to content

  2. → Viewing Profile: Posts: FMode

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

FMode

Member Since 04 Jun 2012
Offline Last Active Jan 03 2015 10:24 PM
-----

Posts I've Made

In Topic: Netduino Plus 2 Firmware v4.2.2

20 January 2013 - 11:12 PM

There is no direct register access, although NETMF unintentionally supports some unsafe pointers. So you might be able to manipulate the CPU registers via some hacking there...

Chris

 

I tried unsafe pointers from http://forums.netdui...fe-port-access/ again but it doesn't work.


In Topic: Netduino Plus 2 Firmware v4.2.2

18 January 2013 - 03:12 PM

Does Netduino 2's Firmware support "peek" and "poke" (direct memory manipulation) - in order to manipulate a cpu register directly? I wrote a LIN driver (which I can share) but it needs UART Break signal (writing bit in the UART control register).


In Topic: Firmware build problem

13 December 2012 - 10:14 PM

Now it works! I think MMP_DAT_CreateDatabase helped...

In Topic: Direct (unsafe) port access

13 December 2012 - 10:12 PM

Here is the patch for 4.2 ...

In Topic: Firmware build problem

13 December 2012 - 08:11 PM

I reinstalled the Porting Kit and finally I was able to compile and run an own unmodified version of the firmware. Then I modified firmware with "native register patch" and now I get 0x00000000 for *Register.dll again :( (other dll's are accepted). Will try with 4.1 ...

  1. Netduino Forums
  2. → Viewing Profile: Posts: FMode
  3. Privacy Policy
home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.