endo

Hi Support,

 

I have set the debugger to COM1 using mfdeploy on the Netduino Plus 2 to program in VS via COM1

I have Deployed the Sample HID keyboard code, originally wrote for the Netduino. When debugging it appears that the USB controller and USB device are starting, but Device manager always shows Netduino. 

I have deployed, and rebooted the device and still the same.

 

I have also tried to use a 7.5 V power supply to power the board, however I cannot program via serial unless the Netduino Plus is connected via USB to the same PC, and external power is disconnected. Im not sure why powering the board would prevent programming.

 

 Are USB devices currently supported? Is there any issues with programming with external power?

 

Thanks again for your support,

endo

 Hi Support,

 

I have attempted to install the NetduinoPlus2_Firmware_4.2.2.0.dfu firmware release and

am unable to recover after flashing.

 

These are my steps.

1. Using DFU Flasher select protocol and Create Empty. Next I selected Erase and Go

2. In dfuSe Demo v 3.0 I select verify after download and choose the above DFU file

It programs ok and verifies. When I press Leave DFU it gives me an error at 49%

 

->Error Code Unexpected error

Operation: Return

Transfer size: 2048

DFU STate: State DFU_IDLE

DFU Stauts: STatus_OK

Request: Awating UNPLUG EVENT

CurrentNBlock: 0x000

CurrentLength: 0x000

Percent 49%

 

When rebooting the Netduino is not detected. I can only get into DFU mode at this point.

This is happening on both of my new boards. Please advise.

Thanks.

 

endo

Hi Support, What version GCC can be used for compiling this firmware on the Netduino plus 2 source? Is there any recomendation excluding RVDS? I tried to compile the default source with "arm-2007q3-53-arm-none-eabi.exe" It is giving several errors the target CPU does not support ARM mode. Thanks!

Hi Netduino Support, When can we expect the firmware beta source for the Netduino plus 2? Thanks!

Hi Everyone, Where can I find the source code for Netduino Plus 2 firmware? It says coming soon. Is there a beta version on Codeplex I can compile? If not, when can we expect this? Thanks!