Hi all
I have a project that requires CANbus - or more specifically, two CANbus networks (they run at different speeds).
There aren't many messages so I'm not worried about latency too much at this point.
I see on the datasheet for the CPU in the N+2 that it supports 2x CANbus interfaces. However, lots of googling shows that it's not in the NetMF/Netduino SDK.
What is involved in creating support? Some sites mention that it is too hard for MicroSoft to build onchip support as there are too many CPUs, but I'd be willing to have a go - trouble is - where do I start?
Thanks in advance
Colin