Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Stefaan

Member Since 08 May 2015
Offline Last Active Jun 06 2015 10:57 PM
-----

Topics I've Started

Unable to deploy: No debugger on device

12 May 2015 - 03:23 PM

Hi,
 
Long story short; I tried to clear my N3 with Netduino Update 4.3.1.0. The task didn't complete, so I killed the app and ended up giving it a hard reset.
 
Now I am unable to deploy new apps, the device is recognized correctly in bootloader- & normal mode. When I ping the N3 with MFDeploy it gives the following result:
 
Pinging... No debugger!
Create TS.
 Loading start at 8065c5c, end 808cb4c
Assembly:NoConnection
 mscorlib (4.3.1.0)
Assembly: Microsoft.SPOT.Native (4.3.1.0)
Assembly: Microsoft.SPOT.Hardware (4.3.1.0)
Assembly: Microsoft.SPOT.Net (4.3.1.0)
Assembly: Microsoft.SPOT.Net.Security (4.3.1.0)
Assembly: System (4.3.1.0)
Assembly: System.Net.Security (4.3.1.0)
Assembly: Microsoft.SPOT.Hardware.SerialPort (4.3.1.0)
Assembly: Microsoft.SPOT.IO (4.3.1.0)
Assembly: System.IO (4.3.1.0)
Assembly: Microsoft.SPOT.Hardware.PWM (4.3.1.0)
Assembly: Microsoft.SPOT.Hardware.Usb (4.3.1.0)
Assembly: Netduino.IP
 
I can't use the Netduino Update tool to install V 4.3.2 as I have 0 write actions left, and the device
is still recognized as 'STM Device in DFU Mode' in bootloader mode.
 
If anyone can tell me if and how the device can be rebuilt, or confirm that I fully noobed out and bricked it, would be much appreciated :).

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.