RiC0MD

Hi All,

Just got my N+2 (my first netduino) and am trying to get my adafruit wifi shield working on it.  I'm using the CC3300 code with patch on codeplex (cc3000.codeplex.com/SourceControl/latest) (patch under the patch section), and see a couple people have this working, but for the life of me I can't seem to make it work.

Some times on power up (wall plug (9V 1a) + usb), I can see the power light on the shield light up for a few seconds, and other times it just stays out complete on boot.  Testing from the shield headers, usually when its doing this I'm reading almost 0 power on the 5v and 0 on the 3.3volt pins, removing the shield yields the same result.

So here's where things get odd:  If I reflash the board back to 4.2, my 5 and 3.3 pins begin to work normally, from there if I attempt to reload the code, the light will go out on the shield, 5 and 3.3 pins seems to fall and the process starts over.

Here's the catch though, since by this point I'd conclude a problem with the shield, if I place this shield on my Uno, every test I can throw at it works perfectly.  

Anyone have any ideas, loosing my mind over this goofy shield.

TIA!