Netduino home hardware projects downloads community

Jump to content

  2. → Viewing Profile: Topics: masterchief

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

masterchief

Member Since 22 Oct 2014
Offline Last Active Nov 21 2014 01:38 AM
-----

Topics I've Started

Netduino 2 com ports 2 and 4 die

30 October 2014 - 01:08 AM

Hi All,

 

We have a Netduino 2 flashed to 4.2.2.

 

We can successfully talk over com ports 1 and 3 (PINs 0/1 and 7/8).  The talking consists of sending a continues stream of short sentence like "this is test1this is test2this is testX.....".

 

Over ports 2 and 4, the receiver just dies after a few iterations.

 

We have tried various baud rates, but in our mind - it should just work.  19200, Parity.None, 8, 1 are the typical settings.

 

Any advice or help?

 

Thanks,

Pete


  1. Netduino Forums
  2. → Viewing Profile: Topics: masterchief
  3. Privacy Policy
home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.