First, install (or upgrade to) .NET Micro Framework v4.2 SDK
Next, reset the Netduino by connecting +3.3V to the metal square below Digital I/O pin 0 while the Netduino is powered up.
Here's the part where I get messed up.
Dowloand SAM-BA 2.11 for Windows
When you finish installation, it will open up a notice by default. If you miss it, it should be located at C:/Program Files (x86)/ATMEL Corporation/sam-ba_2.11/doc/usb_notice.html
To install a driver, you need the inf file located in C:\Program Files (x86)\ATMEL Corporation\sam-ba_2.11\drv
You should install the driver exactly as it says in this notice rather than a generic COM driver like this: http://wiki.netduino...y-Netduino.ashx
I'm attaching a screenshot of what it will look like, but your COM port will likely be different. Take note of the COM port listed beside the newly installed driver, and you're ready to flash the bootloader as described in this post
When the bootloader has been successfully flashed, simply finish the installation of the 2 HEX files as described in this post
Attached Files
- Gutworks likes this