EndlessHunt

Hi

I need some help or pointers in the right direction

I want to monitor some channels from a RC receiver and based on these inputs cycle through digital outputs.

In effect de-mux the RC inputs, i.e. flick the switch on a channel and make io1 high, flick it again and make io1 and 2 high, third flick and make io1 and 2 low.

What I need help with is how do I monitor/decode the RC channel.

Driving a servo from NP2 is not a problem but reading/decoding the RC input is for me.

Cheers

Deon

Hi

This is my first post, well not quite.

I posted replies on two other topics but it looks like it was not seen by any of the moderators to approve it.

The first was on http://forums.netdui...ntrol-in-vbnet/

and the second on http://forums.netdui...-machine/page-9

I just started playing with the ND+2 and I'm having a lot of fun

The last time I worked with uControllers was in the early 80s on the 8051 in assembler code.

What a giant leap forward with these new generation uControllers.

This question must have been asked a lot but I can't find any answers with search.

I'm looking for a .NET library/drivers for the Adafruit i2c / SPI character LCD backpack to use on ND+2

found here http://www.adafruit.com/products/292

I'm using it on a 20*4 white on black LCD found here http://robotics.org....&product_id=616

I would like to experiment with both i2c and SPI

The only library/drivers that I could find was for the Arduino. I'm not sure if it will work without rewriting in .Net

I'm using VB in VS2010 Premium with .NET Micro Framework SDK v4.2 and Netduino SDK v4.2.2.0 (64-bit) 

My ND+2 is currently on v4.2.2.2 firmware

Thanx in advance

Deon