The Netduino forums have been replaced by new forums at community.wildernesslabs.co.
This site has been preserved for archival purposes only
and the ability to make new accounts or posts has been turned off.
I'm new to Netduino so just installed everything.
I have VS 2012 so installed MF framework 4.3 and SDK's 4.3.
I have connect the Plus 2 for the first time and run the deployment
Set the device to USB. Then Target->Device Capabilities ... Got the following ...
IP Address: 0.0.0.0
Not Supported
No debugger!
Create TS.
Loading start at 806a988, end 8085288
Assembly: mscorlib (4.2.0.0)
Assembly: Microsoft.SPOT.Native (4.2.0.0)
Assembly: Microsoft.SPOT.Hardware (4.2.0.0)
Assembly: Microsoft.SPOT.Net (4.2.0.0)
Assembly: System (4.2.0.0)
Assembly: Microsoft.SPOT.Hardware.SerialPort (4.2.0.0)
Assembly: Microsoft.SPOT.IO (4.2.0.0)
Assembly: System.IO (4.2.0.0)
Assembly: Microsoft.SPOT.Hardware.PWM (4.2.0.1)
Assembly: Microsoft.SPOT.Hardware.Usb (4.2.0.0)
Assembly: SecretLabs.NETMF.Diagnosti
Any suggestions ?
Am I going to have to reflash the firmware?
thanks in advance for any help