John Feeney

Thanks JoopC for your reply.

 

I went ahead and redownloaded .Net MicroFramework 4.3 and Netduino 4.3

 

I found MFDeploy was a little stuborn ... get lots of "unsupported" and I chose different menu items. However, I did find that by hitting Device Info and then Device Capablities I was able to get it to display. It says that my version was 4.1.0.5

 

When I go into STDFUTester (v3.0.1) their are no devices showing.

 

Steps:

1. On NetduinoPlus I hold down the pushbutton and plug usb into my computer

2. then I start STDFUTester

Nothing displays

 

I unplugged my NetduinoPlus and then replugged (with STDFUTester still running)....still nothing displays under devices

 

Can someone help with how to "Wake up my device" in STDFUTester?

 

Thanks, John

Hi Chris, I have VS 2012 installed. I installed .Net Micro Framework 4.3 and Netudino 4.3.0.0. Both of these installed ok.

 

I have an Original Netduino Plus. I don't remember upgrading my firmware before (possibility I did shortly after I got it but that would be a good 2 years ago).

 

When I go into .Net Micro Framework Deploy, it says that Target->Device Capabilities is not supported. However, in the listing of items that are displayed when I hit this menu item I believe that I have running .Net MF 4.1.2821.0 Build date Nov 7, 2010

 

When I go into STDFUTester my device is not displayed.

 

Do I need to go up to 4.2 before trying to go to 4.3?

 

Thanks, John

Go into your VS2010 folder (by default My Documents\Visual Studio 2010) and then go into \Templates\ProjectTemplates\C# copy the "Micro Framework" directory to the same directory in your My Documents\Visual Studio 2012 directory.

You should be then good to go. I'm not 100% sure about the location of the VS2012 'My Documents' directory, since I haven't upgraded mine yet (work requirements) but it's extremely likely that VS2012 doesn't use the same templates directory as VS2010, so you'll have to copy them over manually.

--Me.

Hi Coytti

If you look at my original questiona at the top .... that is what I did. I copied the templates from VS2010 to VS2012. So I can select the NetduinoPlus template. But when it goes to open then I get the error.

Either a registery issue or .Net Micro 4.1/4.2 want work with 2012.....I now think it is the latter of those two.

John

So I guess the final answer is to leave VS 2010 installed and wait until later this year for Micro 4.3 and Netudino install update to be able to run on VS 2012. John