Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

cce1911

Member Since 15 Apr 2013
Offline Last Active Jun 19 2014 05:25 PM
-----

Posts I've Made

In Topic: How do I connect Netduino+ to a pc wireless?

05 May 2014 - 01:23 AM

I got everything working. I just needed to boot the Edimax and wait 60 seconds before powering up the N+2. When powering them up at the same time, the N+2 did not see the Edimax, but if I waited a minute, everything worked as advertised.

 

Baxter, yes I have it setup the way you described and port forwarding was not my issue. 


In Topic: Netduino Plus 2 Firmware v4.3.1

04 May 2014 - 11:38 AM

It took me too many hours to figure out that you can't boot up both devices at the same time. You have to boot theEdimax 60 seconds before powering up the N+2.

In Topic: How do I connect Netduino+ to a pc wireless?

03 May 2014 - 06:37 PM

I got the Edimax 6258n and installed but I'm having some issues.

 

Here is my configuration:

  • Belkin N300 Wireless Router
  • No WAN connectivity
  • DHCP turned off
  • Static IP of 192.168.1.1
  • Netduino +2
  • Setup with static IP of 192.168.1.100
  • Laptop PC
  • connected to Belkin N300 wifi
  • Static IP of 192.168.1.29

 

My PC application uses a socket connection to talk to the Netduino on port 9999 and 9998. This works fine in a hard wired environment.  In this environment, I can ping the IP addresses of all the devices, but when I go to establish a socket connection I get an error saying "No connection can be made because the target machine actively refused it."

 

I tried configuring the Port Forwarding feature of the Edimax, but that did not seem to work either.

 

Does anyone have an idea on how to get the Edimax to allow tcp/ip traffic on designated ports?


In Topic: How do I connect Netduino+ to a pc wireless?

29 April 2014 - 02:03 AM

Baxter,

If I could use the USB port, it would make things easier. So I will now go down the path you suggest.

-Capel


In Topic: How do I connect Netduino+ to a pc wireless?

28 April 2014 - 09:07 PM

Could I use a male to male USB cable to power the Edimax BR-6258n NANO via the N+2 if I have a battery providing power to the N+2?


home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.