2 replies to this topic

[weixiongmei]

Instruction please read the readme.txt file in the zip file

 

1.Supports SD1.0/SD2.0 SD/TF cards through SDIO interface

 

2.Supports On Chip RTC

 

3.All pins are configurable through the MFDeploy_WPF.exe without re-compiling the firmware

 

4.Supports debugging ports setting

 

5.Because of test purpose,please contact me ask for the verification key(Serial Key),you have to sent me the the Hardware Serial Number to caculate the Key for you(no cost,it's free).

 

7.Only supports the boards that are using STM32F4XX(1M Flash) and HSE is 8.0Mhz(such as the STM32F407Discovery board)

 

8.To run the MFDeploy_WPF.exe .Net Framework 4.5 is required.

 

9.Reboot and pull high the PA0 for 20s can bring you back to the default debug ports(USB_FS) if you made a fault during setting the debug ports.

[Valkyrie-MT]

Well this is impressive.  Can you post your source code changes for the firmware?  Did you implement the RTC in C++? 

[weixiongmei]

the RTC is currently using C# + C++,there are many changes compares to the offical .net micro framework source code,so i can't describe too much about this,but what i can say is,it also supports FSMC for external Nor/Nand flash,SRAM,LCD display and ENC28J60/DP83848 for ethernet,i will port the SDRAM driver for the STM32 when the STM32F429Discovery board is ready to buy.