Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Power through shield base

Started by adam8797, Jul 22 2013 03:01 PM

shield base

Please log in to reply

No replies to this topic

#1 adam8797

Member

Members
22 posts

Posted 22 July 2013 - 03:01 PM

Is it possible to power the system through the shield base?

I was looking at one of these: http://www.howtronic...PINO_p_102.html

but I wasn't sure if I could power a Go! with it.

Back to Netduino Go

Also tagged with one or more of these keywords: shield base

Hardware → Netduino Go → Questions for a long term MIDI project. Started by Robert Hugo, 07 Jun 2014 Netduino Go, MIDI, Shield Base	11 replies 4271 views	Robert Hugo 05 Jul 2014
Hardware → Netduino Go → Shield base compatible with ITead Arduino 2.8'' TFT LCD Touch Shield? Started by WallieBrooks, 07 Jan 2014 shield base, itead, lcd, touch and 1 more...	0 replies 3949 views	WallieBrooks 07 Jan 2014
Answered Hardware → Netduino Go → PWM using Netduino Go and Shield Base ... Started by DaveFer, 02 Jan 2014 PWM, shield base, go, motor	5 replies 6108 views	DaveFer 05 Jan 2014
Hardware → Netduino Go → Custom Logic on Shield Base to drive SD and Ethernet Started by xlkdxinsanity, 10 Feb 2013 SD, Ethernet, Custom Logic and 1 more...	0 replies 4437 views	xlkdxinsanity 10 Feb 2013
Answered Hardware → Netduino Go → Shield Base - PWM on PIN_10 not working? Started by Piotr Szmyd, 28 Dec 2012 pwm, shield base, servo	4 replies 4177 views	Piotr Szmyd 13 Jan 2013