When unit is alone I can deploy fine but when I piggyback it onto additional electronics I can not deploy. Consequently I can not debug. Every time I try to debug, Visual C always tries to deploy again and I get a deployment failure.
Question 1: Can anyone suggest why I might be unable to deploy when piggybacked onto another pcb? The external circuitry is minimal. It limits the analog and digital voltages to between 0 & 3.3V, it provides 8.6V to the Vin connector and drives a few leds. In theory it ought to be OK...The only worry is that the board will obtain power from Vin while USB is connected for debugging..
Question 2: Are there any alternatives for debugging than USB? Can I use the network, a serial port? or any other type of connection?
regards
philvr
Netduino Plus MK2 Debugging (Deployment) issues when piggybacked onto pcb
Started by philvr, Jun 20 2013 10:08 AM
1 reply to this topic
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users