Hi
Is safe connect the N+2 I2C bus directly to 3.3v I2c bus devices? or need to shift from 5v to 3.3v?
Thanks
  | ||||||||||||||
N+2 to 3.3v I2C
Started by jmanuel, Jun 12 2013 11:57 PM
2 replies to this topic
#1Posted 12 June 2013 - 11:57 PM Hi
Is safe connect the N+2 I2C bus directly to 3.3v I2c bus devices? or need to shift from 5v to 3.3v?
Thanks #2Posted 13 June 2013 - 12:06 AM
Should be just fine. The digital io pins on the N+2 are 3.3v.
#3Posted 14 June 2013 - 09:11 AM I2C is an open drain bus,the votage on the bus is decided by the pull up resistor,both pin for SCL/SDA on ND2+ is 5V tolerant. You can connect it to any i2c device with pull up voltage equal or lower than 5V.
0 user(s) are reading this topic0 members, 0 guests, 0 anonymous users | ||||||||||||||
|
||||||||||||||
This webpage is licensed under a Creative Commons Attribution-ShareAlike License. | ||||||||||||||