4 replies to this topic

[AceInfinity]

I just got my Netduino Go today, started fooling around with it, I had some code working, and after about 5 or 6 debug sessions, I can no longer deploy stuff to the device via USB. It waits forever on the "preparing" stage to upload the assembly, and then gives me an error that it can't see the device. I've seen other people say that you can switch to Serial and back to USB, that didn't fix the issue, and I can't ping the device from any USB port anymore from MFDeploy.

 

My modules had just arrived as well that I bought. Not very impressed so far...

 

Maybe I am doing something wrong though, so I will give the benefit of the doubt.

[NooM]

i _guess_ you have a very tight loop or some crashing code.

 

i make a thread.sleep(some seconds) before my code when iam testing new stuff, so i have time

to overwrite it before it crashes again.

[AceInfinity]

i _guess_ you have a very tight loop or some crashing code.

 

i make a thread.sleep(some seconds) before my code when iam testing new stuff, so i have time

to overwrite it before it crashes again.

 

It doesn't look like it should crash and I don't have a very tight loop either, what would your fix be though?

[NooM]

reflashing. start in dfu mode, reflash firmware

[AceInfinity]

reflashing. start in dfu mode, reflash firmware

 

Thanks Noom That seemed to have solved it. I can now Ping the device and it responds, so things are good.