Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

2 Buttons Wiring

Started by Carsten Dressler, Jan 17 2013 02:18 AM

Please log in to reply

3 replies to this topic

#1 Carsten Dressler

Member

Members
20 posts

Posted 17 January 2013 - 02:18 AM

Hi,

I wired up 1 button using this http://arduino.cc/en/tutorial/button. It works great.

However, I want to wire up more than 1 button. So I want button 1 to trigger D0 and button 2 to trigger D1 for example.

Anyone have any ideas?

Thanks!

Carsten

Back to top

#2 JerseyTechGuy

Advanced Member

Members
870 posts

Posted 17 January 2013 - 02:52 AM

Set it up the same way except button 2 uses a different GPIO pin.

Back to top

#3 supra

Advanced Member

Members
210 posts

LocationOntario, Canada

Posted 17 January 2013 - 12:29 PM

Hi,

I wired up 1 button using this http://arduino.cc/en/tutorial/button. It works great.

However, I want to wire up more than 1 button. So I want button 1 to trigger D0 and button 2 to trigger D1 for example.

Anyone have any ideas?

Thanks!

Carsten

Here is better one:

http://www.instructa...-shield-part-2/

Tutorial for newbie more buttons:

http://www.instructa...ino-Simon-Says/

HTH.

Supra