Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Get files from SD card via usb connection. Is it possible?

Started by zmuro, Jan 03 2013 01:26 PM

Please log in to reply

3 replies to this topic

#1 zmuro

New Member

Members
4 posts

Posted 03 January 2013 - 01:26 PM

Hi.

I have N+ for about two weeks now. I use N+ to take readings from load cell and strore data in to file on SD card. How can I transffer these files to my PC without taking SD card from N+?

And another question. What should I do to make my N+ run for 10s, taking readings from load cell and then write those reading to SD card?

Regards

Back to top

#2 NooM

Advanced Member

Members
490 posts

LocationAustria

Posted 03 January 2013 - 01:47 PM

via usb is not possible, but you can use uart (serial ports) ((edit: maybe its possible, but very hard todo.. switch deployment to serial, and i bet writing an usb driver)

with or without cable, doesent matter.

or if you have a plus or plus 2 you could use ethernet also

My PlayGround and some Code

Back to top

#3 zmuro

New Member

Members
4 posts

Posted 03 January 2013 - 07:38 PM

I have N+ with ethernet, how can I access the content on SD card? Do I need Http Server running on it?

Back to top

#4 JerseyTechGuy

Advanced Member

Members
870 posts

Posted 03 January 2013 - 09:44 PM

I have N+ with ethernet, how can I access the content on SD card? Do I need Http Server running on it?

Doesn't need to be an http server but that does work. You just need to implement some Ethernet enabled protocol to access it. You can also use serial communications using one of the COM ports on the ND+.