Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

How to do simple SD write-read in VB

Started by jmanuel, Dec 23 2012 01:28 AM

Please log in to reply

1 reply to this topic

#1 jmanuel

Member

Members
12 posts

Posted 23 December 2012 - 01:28 AM

Hi I was found some examples in C but I'm not shure how to translate it to VB code, can you show me how to do it with a simple example? Thanks

#2 carb

Advanced Member

Members
352 posts

LocationCrystal River, Florida

Posted 24 December 2012 - 08:56 PM

Hi

I was found some examples in C but I'm not shure how to translate it to VB code, can you show me how to do it with a simple example?

Thanks

JManual,

I assumed that you are wanting to convert C# (C Sharp) to Visual Basic. There are a couple of converts that normally work for me. The one that I use the most is Telerik Converter it converts both directions.

Chuck