3 replies to this topic

[yiulsup]

To Netduino Community. After .net mf 4.2 compiling with RVDS 4.0, i flashed bootloader(tinydecompressor.bin) and .net mf version 4.2 (ER_CONFIG, ER_FLASH). It worked very well in opration excluding the Ethernet Function. I tried to register the number of IP Address, and Gateway on MFDeploy for Ethernet Connection. But Even if to modify the IP Adddress on MFDeploy, ND+ didn't work on MFDeploy. The more worse is to lost the .net mf and reboot with bootloader of tinybooter. My steps are .... 1. To compile with msbuild /t:build /p:flavor=release;tcp_ip_stack=lwip /v:m /m 2. With SAMBA, I flashed bootloadder. i check the bootloader with MFDeploy. 3. To flash the .net mf with MFDeploy. 4. To configure the IP Address for .NET MF of ND+. 5. It didn't work. ... The other function such as GPIO and SPI were working well..... Thanks. Kevin

[yiulsup]

I coudn't modify the IP Address and Gateway on MFDeploy. when i tried above, MFDeploy was useless or lost connection with ND+ Thanks Kevin

[Chris Walker]

Hi Kevin,

I coudn't modify the IP Address and Gateway on MFDeploy.

when i tried above, MFDeploy was useless or lost connection with ND+

Please start the board in TinyBooter mode...and see if you can set the IP settings there.

Chris

[caEstrada]

Hi Kevin,


Please start the board in TinyBooter mode...and see if you can set the IP settings there.

Chris

Chris,

I had similar problem and you suggested to fix the IP thing with:

byte[] MAC = { 0x5C, 0x86, 0x4A, 0x00, 0x4E, 0x5A };

Microsoft.SPOT.Net.NetworkInformation.NetworkInterface.GetAllNetworkInterfaces()[0].EnableStaticIP("192.168.1.102", "255.255.255.0", "192.168.1.254");
Microsoft.SPOT.Net.NetworkInformation.NetworkInterface.GetAllNetworkInterfaces()[0].PhysicalAddress = MAC;
//Microsoft.SPOT.Net.NetworkInformation.NetworkInterface.GetAllNetworkInterfaces()[0].EnableDhcp();

Kind of a workaround...regards,